![]() Spray solution on the outside of the film and press the tinting film firmly to the glass using the squeegee.Fold up the bottom edge of the tinting film to help keep any remaining dust from adhering to the film.Leave about a ⅛ inch gap between the top of the glass and the tinting film. Use your hands to smooth out any wrinkles and position the film on the window.Carefully lift the film from the outside of the glass and place the wet adhesive against the wet glass on the inside of the car. Generously spray the inside of the window with the soapy solution.As you pull the liner away, spray the newly exposed adhesive with the soapy solution. Slowly separate the two layers to expose the adhesive. Firmly hold the tape attached to the film as you pull the piece of tape attached to the liner up and away from the window. Now, use the two pieces of tape to remove the clear liner.Remember to clean on and between gaskets. Clean the window thoroughly using a squeegee and low-lint cloth to dry. Spray the inside of the vehicle’s window with the soapy solution.Run the blade all across the top of the window and down, along the mirror as well. Trim the excess film on the top of the window by using the edge of the glass as your guide. Then, roll the window down about 2 inches. Carefully lift the film from the bottom of the glass. Before trimming the top edge of the car glass tinting film, open the door of the vehicle.Try to do this in one smooth and controlled movement. Avoid using excessive pressure so as not to accidentally scratch or damage the glass. Press lightly on the blade as you cut and hold the blade at a low angle. Use the utility blade to cut along the vertical side of the glass.Take the squeegee and use the rubber edge to gently smooth the film onto the glass from the top to the bottom, working from one side of the window to the other in continues, overlapping strokes.Ensure that the film is totally wet with the solution. Spray the outside of the window film’s liner with the water and soap solution.Position the film so that the bottom edge extends from a ¼ or ½ inch below the top of the inside car window seal. Use a utility tool with a new blade to cut away the excess glass tinting film. Roll it out with the liner side facing outward. Using a spray bottle filled with a water and soap solution, make sure that the entire surface of the window is wet. ![]() In step 10, this will allow you to pull the clear protective liner from the car glass tinting film. Stick one piece of tape to each side of the film’s corner with half of the tape adhered to the film and the other half extending past the edge. To separate the tinting film from the liner, prepare two pieces of transparent tape.Wipe down the gaskets and clean as far into the gap between the gasket and the glass as possible. Dry with a squeegee and a low-lint cloth. It’s imperative the glass be completely clean because dirt and dust will cause the tinting film to bubble. Clean the glass thoroughly with glass cleaner and a scrub sponge.For example, in Pennsylvania, vehicle window tinting requires 70% light transmittance for most types of cars. Car Glass Tinting Film Applicationīefore getting started, check your state laws regarding car glass tinting. But not every car owner knows how to apply and clean car glass tinting film like a pro. Many car owners want to apply car glass tinting film to protect the inside of their vehicle from the sun’s heat and damaging UV rays. Posted in Auto Glass Care Tips Apply and Clean Car Glass Tinting Film Like a Pro Written by Anthony Volk on July 10, 2018.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |